University of Tasmania

File(s) under permanent embargo

Can soil crusting be reduced through application of gypsum, organic waste, and phosphoric acid?

journal contribution
posted on 2023-05-19, 13:06 authored by Almajmaie, A, Marcus HardieMarcus Hardie, Tina AcunaTina Acuna, Birch, C
Soil crusting is a form of land degradation in which the breakdown of aggregates results in the formation of a thin impermeable layer on the soil surface. An earlier pilot trial indicated that application of paper waste, gypsum, phosphoric acid, and covering the soil surface with wire mesh showed potential for reducing soil crusting. This study was established to evaluate the use of products for reducing the severity of soil crusting, while also testing different approaches for measuring the severity and likelihood of soil crust formation. Gypsum was applied at 0.25 and 0.50 kg m–2 (low rate [LG] and high rate [HG], respectively), paper waste was applied at 1, 2.5, and 7.5 kg m–2 (low [LPW], moderate [MPW], and high [HPW] rates, respectively), and phosphoric acid was applied at 80 and 160 mL m–2 (low rate [LP] and high rate [HP], respectively). Combinations of these products were made including (1) wire mesh (WM) and 0.50 kg m–2 gypsum (WM + HG); (2) 0.50 kg m–2 gypsum and 80 mL m–2 phosphoric acid (HG + LP); (3) 2.5 kg m–2 paper waste, 0.50 kg m–2 gypsum, and 80 mL m–2 phosphoric acid (MPW + HG + LP); and (4) 7.5 kg m–2 paper waste and 160 mL m–2 phosphoric acid (HPW + HP). The likelihood of crust formation was inferred from aggregate stability determined by rainfall simulation and wet sieving, while the severity of soil crusting was inferred from crust density, hydraulic conductivity, and penetration resistance. The four measures of crust severity/likelihood were highly correlated with each other (R2 = 0.57 to 0.80). The HPW + HP, MPW + HG + LP, and MPW treatments increased hydraulic conductivity by 72%, 66%, and 45%, respectively; increased aggregate stability determined by rainfall simulation by 28%, 37%, and 39%, respectively; reduced surface density by 10%, 7%, and 6%, respectively; and reduced penetration resistance by 33%, 37%, and 34% as average at all five sampling dates (days 8, 14, 28, 71, and 197). Moreover, the high rate of gypsum significantly reduced bulk density by 7% and penetration resistance by 26%, yet had no effect on any other measure of crusting. Phosphoric acid (HP) significantly increased aggregate stability determined by rainfall simulation by 29% (days 8, 14, 28, and 71), reduced bulk density by 6% (days 8 and 14), and increased hydraulic conductivity at day 8 by 110%. Reduced severity and or likelihood of crust formation following application of gypsum and paper waste were attributed to the increase in calcium cations (Ca+2) and soil organic carbon (C). The paper waste and gypsum were the most effective amendments over the duration of the trial, while phosphoric acid reduced the severity of crust formation in the 14 days after application. Recommendations are provided on the efficiency of different approaches for measuring soil crusting, in which penetration resistance is preferable because of its high correlation with other measurements and being the least time consuming.


Publication title

Journal of Soil and Water Conservation










Tasmanian Institute of Agriculture (TIA)


Soil Water Conservation Soc

Place of publication

7515 N E Ankeny Rd, Ankeny, USA, Ia, 50021-9764

Rights statement

Copyright 2017 Soil and Water Conservation Society

Repository Status

  • Restricted

Socio-economic Objectives

Evaluation, allocation, and impacts of land use

Usage metrics

    University Of Tasmania


    Ref. manager